Lime Kiln Features and Wheel Belt Failure Solutions

Lime Kiln is an important tool for producing lime raw materials, and it has strong technical requirements. When lime kiln is used in the production process, the use of lime kiln to produce lime will go through many processes, and in these concrete working procedures, the related effects and requirements are clearly defined. In order to ensure the quality of lime, it must be strictly followed corresponding regulations.

First,the characteristics of lime kiln

1.Thetechnical characteristics of the lime kiln production process. Lime Kiln is animportant tool for producing lime raw materials, and it has strong technicalrequirements. When lime kiln is used in the production process, the use of limekiln to produce lime will go through many processes, and in these concreteworking procedures, the related effects and requirements are clearly defined.In order to ensure the quality of lime, it must be strictly followedcorresponding regulations. And there are many things to be aware of whenoperating a lime kiln, and it is necessary to have a certain technical abilityto easily control the lime kiln's related work. At the same time, there will bemany aspects involved in the operation of the lime kiln. For example, the useof fuel will produce atmospheric pollution, and the requirements forenvironmental protection technologies will emerge.

2.The structural characteristics of the lime kiln production process. Thestructure of the lime kiln is usually round and quasi-rectangular, and adouble-layer combustion beam is arranged on the kiln body of the lime kiln anda burner is arranged around the kiln, and the suction beam is arranged abovethe kiln body and on the upper part thereof limestone storage sites.Limestone-related calcinations are performed using this structure and thenproperly cooled through the more common and popular dual-beam limestone shaftkiln. Finally, lime is formed as a result of the associated processing of thestorage area, the two-layer combustion beam and the upper suction beam. Thestructure of the lime kiln plays a vital role in the lime production process.The lime kiln must strictly follow the structural characteristics of the limekiln.

3.Technical and economic index type characteristics of lime kiln productionprocess. At the same time, in the selection of lime kiln, we must pay attentionto the technical and economic indicators of the lime kiln. Through the relevanttechnical and economic requirements for the lime kiln, the selection of thelime kiln has a certain scientific rationality. The estimation of dailyproduction and annual production budget must also be based on actualconditions. The most important thing is that the consumption of fuel and energymust be controlled within a reasonable range and the relevant smoke and dustemissions must be handled effectively. While meeting lime production, we mustpay attention to the combination of economic benefits, environmental benefits,and social benefits so that the technical and economic indicators of the limekiln meet certain rigid requirements.

Second,the lime kiln belt fault response method

Thewheel belt assembly is an important component of the rotary kiln, and therotation kiln wheel belt is faulty and cannot be quickly repaired. The solutionis very important. Following the instructions below can also reasonably reducethe failure between the wheel belt and the gear wheel, which is a good way toreduce the equipment failure rate.

1.Inject grease into the third gear support surface to force the kiln body todescend axially until the horseshoe between the guide bars on both sides of thetailgate is fully compressed.

2.The oil pressure in the cylinder of the rear wheel is unloaded.

3. Ittakes 1.5 minutes for the slow speed rotary kiln shell to turn around.

4.Through the hydraulic device of the rear stop wheel, push the kiln body to itsaxially upward position, so that the middle wheel belt and the middle stopwheel leave contact, and the gap between the two can maintain a distance of20mm.

5.Plug the horseshoe horn between the guide rods on both sides of the rear wheel.